Part Description:
Stainless Steel Extractors / Headers

UZ Model Compatability:
All UZ engine family

Specifications of Part:
1 3/4" Primary Pipe LONG Tube set.
Short tube TUNDRA set

Manufacturers Usage Recommendation:
Long Tube is ONLY for UZZ3* Series Soarer and UZA80 Converted Supra.

Tundra set to be used at buyers discretion. ( Unknown exactly what they will / wont fit )

Other/Modified Usage Suggestion:
Some engine conversions / Buggies / Off Road etc.

Specific Indications for Use of Part:
Exhaust Improvement.

Specific Contraindications for Use of Part:

Measured Benefit of Part:
Average of 13 RwKw I have been advise over the years.
Plus Torque benefits.

Identified Problems with Part:
None

Suggestions for Improvement:
Extra o2 Sensor allocation in collectors ( This will be happening on next lot manufactured )
This will be to run Wide Band Sensors to After Market ECU's.

Approximate Retail Price:
Long Tube $770
Tundra $TBA

Retail Source & Contact Details:
RUSH IMPORTS
5 SIlva AVe
Queanbeyan
NSW 2620
Ph 02-6284-3111
sales@rushimports.com.au

Overall Rating:
TBA

Part Image
To come

*Shipment should be here by end of November 2009*

Any pics on the short headers?

There ya go.

$330 for the Tundra units plus shipping.

Long Tube are $660.

will these fit the gs400 98-2003? look like they'll work anyone try?

I would like to know the same.

I have no idea if they will.
We do not have the GS400 here

Looking at my V8 Aristo ( GS400 you's did not get ) I do not think the Long Tubes will fit. As the floor is as low as the LS400.

The Aristo is called the GS out here. Unless I'm mistaking what you are saying. What about the short ones? Do you make any long ones for the V8 Aristo?

No mate, I don't do any short one for the GS either.

The floor on the GS is as flat as the LS, this hinders the fitment of any long tube headers.

My V8 Aristo is 4WD.